AirLive IP-2000VPN User Manual

Page 12

AirLive IP-2000VPN User’s Manual

4. Power

• Power on the Broadband modem.

• Connect the supplied power adapter to the IP-2000VPN and power up. Please note that you should

use only the power adapter provided. Using a different one may cause hardware damage.

5. Check the LEDs

• The

Power

LED should be ON.

• The

Status

LED should blink during start up, and then turn Off. If it stays on, there is a hardware

error.

• For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is also ON).

• If a PC is connected to the DMZ port, the DMZ port's Link/Act LED should be ON (provided the PC is

also ON).

• The

WAN

LED should be ON.

6. Router’s default IP

• The default IP address of router’s LAN port is:

IP Address:

192.168.1.1

Subnet Mask: 255.255.255.0

• For Web Management, please configure client PC as DHCP client to obtain IP address from

IP-2000VPN.

• After configuring the computer’s IP properly, please enter the router’s IP address “192.168.1.1” in

Web browser to manage the router, type the proper user name and password to pass the router’s

authentication.

7. User name and password

• User’s

name:

admin

• Password:

airlive