AirLive IP-2000VPN - Manual (Page 137)

9.1 Connection Status – PPPoE
If using PPPoE (PPP over Ethernet), a screen like the following example will be displayed when the
"Connection Details" button is clicked.
Data – PPPoE Screen
Connection
Physical Address The hardware address of this device, as seen by remote devices on the
Internet. (This is different to the hardware address seen by devices on the local
LAN).
IP Address
The IP Address of this device, as seen by Internet users. This address is
allocated by your ISP (Internet Service Provider).
Network Mask The Network Mask associated with the IP Address above.
PPPoE Link Status This indicates whether or not the connection is currently established.
• If the connection does not exist, the "Connect" button can be used to
establish a connection.
• If the connection currently exists, the "Disconnect" button can be used to
break the connection.
Connection Log
Connection Log
• The Connection Log shows status messages relating to the existing
connection.
• The most common messages are listed in the table below.
• The "Clear Log" button will restart the Log, while the Refresh button will
AirLive IP-2000VPN User’s Manual 134