AirLive IP-2000VPN User Manual

Page 159

AirLive IP-2000VPN User’s Manual

156

Properties

• Destination Network - The network address of the remote LAN segment. For

standard class "C" LANs, the network address are the first 3 fields of the

Destination IP Address. The 4th (last) field can be left at 0.

• Network Mask - The Network Mask for the remote LAN segment. For class

"C" networks, the default mask is 255.255.255.0

• Gateway IP Address - The IP Address of the Gateway or Router which the

IP-2000VPN must use to communicate with the destination above. (NOT the

router attached to the remote segment).

• Interface - Normally, this will be "LAN". If NAT is disabled, the "WAN" option

can be used for Routers which are accessed via the WAN port.

• Metric - The number of "hops" (routers) to pass through to reach the remote

LAN segment. The shortest path will be used. The default value is 1.

Buttons

Save

Save the RIP setting. This has no effect on the Static Routing Table.

Add

Add a new entry to the Static Routing table, using the data shown in the

"Properties" area on screen. The entry selected in the list is ignored, and has no

effect.

Update

Update the current Static Routing Table entry, using the data shown in the

"Properties" area on screen.

Delete

Delete the current Static Routing Table entry.

Clear Form

Clear all data from the "Properties" area, ready for input of a new entry for the

Static Routing table.

Generate Report

Generate a read-only list of all entries in the Static Routing table.

Configure others Router on your LAN

It is essential that all IP packets for devices not on the local LAN be passed to the IP-2000VPN, so that they

can be forwarded to the external LAN, WAN, or Internet. To achieve this, the local LAN must be configured to

use the IP-2000VPN as the Default Route or Default Gateway.

Local Router

The local router is the Router installed on the same LAN segment as the IP-2000VPN. This router requires

that the Default Route is the IP-2000VPN itself. Typically, routers have a special entry for the Default Route.

It should be configured as follows.

Destination IP Address

Normally 0.0.0.0, but check your router documentation.

Network Mask

Normally 0.0.0.0, but check your router documentation.

Gateway IP Address

The IP Address of the IP-2000VPN.

Interface

LAN

Metric