beautypg.com

Main assembly, Main assembly -36 – JLG 510AJ Service Manual User Manual

Page 78

background image

SECTION 3 - CHASSIS AND TURNTABLE

3-36

– JLG Lift –

3121181

9.

Place spacer (1H) on spindle (1A) in hub (1G).

NOTE:

Make sure retaining ring is securely seated in groove.

10.

Place retaining ring (1I) over spacer onto spindle (1A) in
hub (1G).

11.

At this point hub-spindle sub-assembly is complete.

Main Assembly

BEWARE OF SHARP EDGES IN COUNTERBORE WHEN INSTALLING THE O-RING

1.

Grease O-ring (5) and place it in hub counterbore (1G).

NOTE:

O-ring may be stretched or pinched together to make it fit
counterbore.

2.

Oil all exposed surfaces inside hub (1G).

Place internal gear (2) in hub (1G) so its internal splines
mesh with external splines of spindle (1A). Oil internal
gear (2).

See also other documents in the category JLG Special machinery: