JLG 510AJ Service Manual - Manual (Page 328)

SECTION 6 - JLG CONTROL SYSTEM
6-46 – JLG Lift – 3121181
JIB:
10* 0
1
NO: No jib installed.
YES: Jib installed which has up and down movements only.
0
* Only visible under certain model selections.
4 WHEEL STEER:
11* 0
1
NO: No four-wheel steer installed.
YES: Four-wheel steer installed.
0
* Only visible under certain model selections.
SOFT TOUCH/
SKYGUARD:
12* 0
1
2
3
None: No soft touch or SkyGuard system installed.
SOFT TOUCH - Soft touch only installed.
SKYGUARD - Skyguard only installed.
BOTH(CUTOUT) - Soft touch and Skyguard installed.
0
* Only visible under certain model selections.
GEN SET/WELDER:
13 0
1
NO: No generator installed.
BELT DRIVE: Belt driven setup.
0
GEN SET CUTOUT:
14* 0
1
MOTION ENABLED: Motion enabled when generator is ON.
MOTION CUTOUT: Motion cutout in platform mode only.
0
* Only visible if Gen Set / Welder Menu selection is not 0.
H & T LIGHTS:
15 0
1
NO: No head and tail lights installed.
YES: Head and tail lights installed.
0
CABLE SWITCH:
16* 0
1
NO: No broken cable switch installed.
YES: Broken cable switch installed.
0
* Only visible under certain model selections.
* Certain market and model selections will alter the default setting.
Table 6-6. Machine Configuration Programming Information Software Version P6.1 to Present
Configuration Label/
Digit
Number Description
Default
Number