JLG 510AJ Service Manual - Manual (Page 347)

SECTION 6 - JLG CONTROL SYSTEM
3121181 – JLG Lift – 6-65
CALIBRATION DATA
BASKET UP XXX Displays the basket up calibration point
Basket DOWN XXX Displays the basket down calibration point
L FWD DRIVE XXX Displays the left forward drive calibration point
R FWD DRIVE XXX Displays the right forward drive calibration point
L REV DRIVE XXX Displays the left reverse drive calibration point
R REV DRIVE XXX Displays the right reverse drive calibration point
F LT STEER XXX Displays the forward left steer calibration point
F RT STEER XXX Displays the forward right steer calibration point
R LT STEER XXX Displays the reverse left steer calibration point
R RT STEER XXX Displays the reverse right steer calibration point
U LIFT UP XXX Displays the upper lift up calibration point
U LIFT DOWN XXX Displays the upper lift down calibration point
U TELE IN XXX Displays the upper telescope in calibration point
U TELE OUT XXX Displays the upper telescope out calibration point
BM ANG 1 LO XXX Displays the boom angle 1 low calibration point
BM ANG 1 HI XXX Displays the boom angle 1 high calibration point
BM ANG 2 LO XXX Displays the boom angle 2 low calibration point
BM ANG 2 HI XXX Displays the boom angle 2 high calibration point
LEN RETRACT XXX Displays the length sensor retracted calibration point
LEN EXTEND XXXXX Displays the length sensor extended calibration point
LEN WIT XXXXX Displays the witness mark calibration point
LEN SWITCH XXXX Displays the length switch calibration point
DATALOG:
ON XXXXhXXm Displays total controller on (EMS) time
ENGINE XXXXhXXm Display engine run time
DRIVE XXXXhXXm Displays total controller drive operation time
LIFT XXXXhXXm Displays total controller lift operation time
SWING XXXXhXXm Displays total controller swing operation time
TELE XXXXhXXm Displays total controller telescope operation time
MAX TEMP XXC Displays maximum measured ambient temp.
MIN TEMP XXC Displays minimum measured ambient temp.
MAX volts XX.XV Displays maximum measured battery voltage
RENTAL XXXXhXXm Displays total controller operation time. NOTE: can be
reset
ERASE RENTAL? Not available at Access Level 2.
ENTER resets rental data log time to zero.
Table 6-8. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1 st Line)
Parameter
(Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description