JLG 510AJ Service Manual - Manual (Page 45)

SECTION 3 - CHASSIS AND TURNTABLE
3121181 – JLG Lift – 3-3
Main Disassembly
1. Perform Roll Check, Leak Check and Brake Check if appli-
cable before disassembling the unit.
2. Drain oil from unit. Note condition and volume of oil.
3. Remove Input Coupling (9) from Spindle (1A) end of
unit.
4. Remove Cover Bolts (14) and remove Cover (6).
5. Remove O-ring (19) and Thrust Spacer (10) from Cover
(6).
6. Remove Input Sun Gear (17) from Input Carrier Sub-
Assembly (3A).
7. Remove Input Carrier Sub-Assembly (3A) from Housing
(1E).
8. Remove Output Sun Gear (8) from Output Carrier Sub-
Assembly (4A).
9. Remove Input Shaft (7) from Output Carrier Sub-Assem-
bly (4A).
10. Remove Output Carrier Sub-Assembly (4A) from Hous-
ing (1E).
6. Cover 14. Cover Bolts
9. Input Coupling 19. O-ring
10. Thrust Spacer
Figure 3-1. Main Disassembly Drawing 1