JLG 510AJ Service Manual - Manual (Page 306)

SECTION 6 - JLG CONTROL SYSTEM
6-24 – JLG Lift – 3121181
10 EXT. AXLES: Displays/adjusts
extendable axle
presence. NOTE:
Not Displayed 0=NO No Extendable Axles installed 0
1=YES 1 Yes
11 4WS: Displays/adjusts
4 wheel steer
presence 0=NO No 4 wheel steer installed 0
1=YES Yes
12 JIB BLOCK: Displays pres-
ence of jib block
limit switch.
NOTE: Not Dis-
played 0=NO No Jib Block switch 0
1=YES 1 Yes
13 SOFT
TOUCH: Displays pres-
ence of soft
touch system 0=NO No Soft Touch System installed 0
1=YES Yes
14 GEN SET/
WELDER: Displays/adjusts
presence of gen-
erator/welder 0=NO No Generator/welder installed 0
1=BELT DRIVE Belt drive generator/welder installed
2=HYD DRIVE Hydraulic driven generator/welder installed
15 H & T LIGHTS: Displays pres-
ence of head and
tail lights 0=NO No Head and Tail Lights installed 0
1=YES Yes
16 CABLE
SWITCH: Displays pres-
ence of broken
cable switch 0=NO No Broken Cable Switch installed 0
1=YES Yes
17 TURNTABLE
POSITION
SWITCH: Displays pres-
ence of turntable
position switch.
NOTE: Not Dis-
played 0=NO No Turntable Position Switch installed 0
1=YES 1 Yes
18 LOAD: Displays pres-
ence/function of
load sensor 0=NO No load sensor installed. 0
1=WARN ONLY Boom and drive function in creep, overload lamp
lit, Platform Alarm sounds continuously
2=WARN & CUTOUT All functions cutout, flash overload light (500mS
on, 500mS off ), Platform Alarm beeps (5 sec on,
55 sec off, 5 sec on)
3=SPECIAL 1 As 1=WARN ONLY, but disable upper telescope
out and upper lift up
Table 6-1. Machine Set-Up Parameters
Configurati
on
Digit
Parameter
Displayed on
Analyzer
Line 1
Description
Parameter
Value
Definition
Defaul
t
Numb
er