JLG 510AJ Service Manual - Manual (Page 346)

SECTION 6 - JLG CONTROL SYSTEM
6-64 – JLG Lift – 3121181
MOMENT: Displayed if MODEL NUMBER = 7 or 8
(LB-IN) ACTUAL XXXXXXXX Displays current moment value
(LB-IN)
OVER XXXXXXXX Displays current over moment setpoint.
(LB-IN)
UNDER XXXXXXXX Displays current under moment setpoint.
CAL PT
UNDER XXXXXXXX Displays the under moment value recorded during boom
sensor calibration.
CAL PT
WIT YEL XXXXXXXX Displays the yellow witness mark moment value recorded
during boom sensor calibration.
CAL PT
WIT GRN XXXXXXXX Displays the green witness mark moment value recorded
during boom sensor calibration.
CYL PIN
RATIO X.XXX Displays the current cylinder moment pin ratio of X and Y
forces.
PIN
E FLAGS 0xXXXX Displays the current error flag status of the cylinder
moment pin.
sky welder YES/NO Displays the status of Sky Welder selected during boom
sensor calibration. (Displayed if MODEL NUMBER = 7 or 8)
sky cutter YES/NO Displays the status of Sky Cutter selected during boom
sensor calibration. (Displayed if MODEL NUMBER = 7 or 8)
sky glazier YES/NO Displays the status of Sky Glazier selected during boom
sensor calibration. (Displayed if MODEL NUMBER = 7 or 8)
sky Bright YES/NO Displays the status of Sky Bright selected during boom
sensor calibration. (Displayed if MODEL NUMBER = 7 or 8)
Pipe Racks YES/NO Displays the status of Pipe Racks selected during boom
sensor calibration. (Displayed if MODEL NUMBER = 7 or 8)
Camera mount YES/NO Displays the status of Camera Mount selected during
boom sensor calibration. (Displayed if MODEL NUMBER =
7 or 8)
ENVELOPE: Displayed if MODEL NUMBER = 7 or 8
LENGTH XXXX.X Displays the current indicated boom length in inches.
ANGLE 1 XX.X Displays the current indicated boom angle 1 in degrees.
ANGLE 2 XX.X Displays the current indicated boom angle 2 in degrees.
A/D LNGTH XXXXX Displays the current indicated boom length in A/D counts.
A/D ANG1 XXXXX Displays the current indicated boom angle 1 in A/D counts
or raw angle if calibrated.
A/D ANG2 XXXXX Displays the current indicated boom angle 2 in A/D counts
or raw angel if calibrated.
CAN STATISTICS: CAN Statistics as detected by the Ground Module
RX/SEC XXX Displays the number of received messages per second
TX/SEC XXX Displays the number of transmitted messages per second
BUS OFF XX Displays the number of bus off occurrences
PASSIVE XX Displays the number of bus passive occurrences
Table 6-8. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1 st Line)
Parameter
(Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description