JLG 510AJ Service Manual User Manual
Page 344
SECTION 6 - JLG CONTROL SYSTEM
6-62
– JLG Lift –
3121181
hi TILTED -
NO/YES
Displays status of hi tilt input. (Displayed if external tilt sen-
sor is configured)
AUX POWER
OP/CL
Displays the status of the auxiliary power switch input
HORN
OP/CL
Displays the status of the horn input
R FILTER
OP/CL
Displays the status of the return hydraulic filter by-pass
switch. Displayed ONLY if MODEL = 600 (Configuration
digit = 3)
C FILTER
OP/CL
Displays measured status of charge pump filter bypass
switch. Displayed ONLY if MODEL = 600 (Configuration
digit = 3)
JIB BLOCK
OP/CL
Displays jib block limit switch status. Not displayed if asso-
ciated configuration digit = 0
BASKET STOWD
YES/NO
Displays status of basket stowed mode. (Displayed if
MODEL NUMBER = 7 or 8)
SOFT LIMIT
OP/CL
Displays status of soft touch limit switch. Not displayed if
associated configuration digit = 0
SOFT O/R
OP/CL
Displays status of soft touch override switch. Not dis-
played if associated configuration digit = 0
GEN SET/WELDER
OP/CL
Displays generator/welder switch input status. Not dis-
played if associated configuration digit = 0
LIGHTS
OP/CL
Displays head and tail light switch input status. Not dis-
played if associated configuration digit = 0
bsk tilt1
XX.X
Displays indicated platform tilt angle. Displayed on mod-
els equipped with Electronic Platform Leveling.
bsk tilt2
XX.X
Displays indicated platform tilt angle. Displayed on mod-
els equipped with Electronic Platform Leveling.
axle RET sw
OP/CL
Displays status of axle extension user switches. (Displayed
if MODEL NUMBER = 7 or 8)
axle EXT sw
OP/CL
Displays status of axle retraction user switches. (Displayed
if MODEL NUMBER = 7 or 8)
axle lim sw
RET/EXT
Displays status of axle extension limit switches. (Displayed
if MODEL NUMBER = 7 or 8)
dos lim sw
OP/CL
Displays status of Drive Orientation System Limit Switch.
(Displayed if MODEL NUMBER = 7 or 8)
dos o/r SW
OP/CL
Displays status of Drive Orientation System Override
switch. (Displayed if MODEL NUMBER = 7 or 8)
CAPACITY SW
500/1000
Displays status of capacity selection switch. (Displayed if
MODEL NUMBER = 7 or 8)
Table 6-8. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1
st
Line)
Parameter
(Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description