JLG X17J Plus Operator Manual - Manual (Page 92)

PROCEDURE FOR ROUTINE MOVEMENT OF THE AERIAL PART
• Before moving the aerial part, make sure that:
‑
all instructions provided in this chapter have been complied with;
‑ there are no obstacles in the work area;
‑ all the conditions necessary for working at a height are met:
the machine is stabilised and levelled: icon 5 shown on the display,
the weight in the basket is below the maximum allowed,
the remote control is positioned in the basket.
‑
the basket access ladder has been folded into the raised position so as not to risk
contact during movement of the aerial part.
• The aerial part can ONLY be moved from the control position in the basket.
• Select the motor speed as required and check the selection on the display.
• Use joysticks 2, 3, 4, 5, 6, 7 to move the aerial part as described in the paragraph regar‑
ding the description of the controls.
• If the movements are selected when one of the conditions listed above is not satisfied, an
error message will be shown on the display indicating what conditions are OK and what
are not satisfied (FAIL). If the missing condition is stabilisation, the message will also
indicate what stabiliser is not resting on the ground.
ST1: if OK stabiliser 1 is resting on the ground
ST2: if OK stabiliser 2 is resting on the ground
ST3: if OK stabiliser 3 is resting on the ground
ST4: if OK stabiliser 4 is resting on the ground
INLC: if OK the machine is under the maximum inclination limit
LOAD: if OK, the load is less than the maximum working load
allowed
BASKET:
if OK the remote control is in place in the basket
PEDAL : if OK the footswitch is pushed
X17JPR0020413 88
BOOM LIFT MODELS X17JPLUS
JLG
ERROR
ST1 NO
ST2 NO
ST3 NO
ST4 NO
INCL OK
LOAD OK
BASKET OK
PEDAL OK