JLG X17J Plus Operator Manual - Manual (Page 86)

‑ Stabilisation will be completed when the machine is in horizontal position with toleran‑
ce of 1° and lifted at least 5 cm from the ground. Correct stabilisation will be confirmed
by the icon in position 5 on the display.
Always check the spirit level and make sure the slope is actually less than 1°.
MANUAL STABILISER CONTROL
The manual control of the stabilisers must not be used to stabilise the machine but only to
correct its inclination in the event of stabilisation in difficult conditions. It can also be used to
lower or lift the stabilisers individually in order to increase the stability of the machine, if it is
necessary to transit areas with obstacles or steep slopes.
Pressing the button once shows the screen for the manual operation of stabiliser 1, pressing it
a second time shows the screen for stabiliser 2 and so on until stabiliser 4. Pressing it once
again shows the initial display.
In the manual menu, pressing buttons 1 and 7 raises or lowers the selected stabiliser.
To verify the inclination of the chassis a spirit level is provided on the machine; when the air
X17JPR0020413 82
BOOM LIFT MODELS X17JPLUS
JLG