JLG X17J Plus Operator Manual - Manual (Page 135)

7.21 CHECKING TIGHTNESS OF THE TURNTABLE BOLTS
Check the correct tightness of the top and bottom bolts on the turntable according to the
intervals specified in the routine maintenance table.
The bolts must be tightened to a torque of 248 Nm.
7.22 BATTERY: CHECKS AND MAINTENANCE THERMIC VERSION
‑ Do not use naked flames or produce sparks near the battery (explosive gases).
‑ The battery contains diluted sulphuric acid, which is highly explosive.
‑ Proceed with care, shielding your eyes and face.
‑ In case of accidental contact with the sulphuric acid, rinse immediately with plenty of
running water.
‑ Before working on the battery, ALWAYS disconnect the battery cutout switch.
7.22.1 CHECKING THE ELECTROLYTE LEVEL THERMIC VERSION
The battery does not need to be topped up.
However, if the electrolyte, with the machine on a level
surface, is below the minimum allowed level (MIN.), it is
possible to top up by removing the lid “A” and adding
distilled water without exceeding the maximum level
(MAX.). Only for no AGM technology battery (Absorbed
Glass Mat)
If the machine is going to remain unused for more than one month, it is advisable to insulate
the battery:
‑
Disconnect the battery terminals, always starting from the negative pole (‑).
‑ Reconnect the cables, always starting from the positive pole (+).
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
131
Fig. 1