JLG X17J Plus Operator Manual - Manual (Page 85)

The complete closure and alignment is displayed by the arrows on the machine (SEE
PHOTO) and the display of the icon in position 6 on the remote control.
‑ Stabilisation can be carried out from the control position in the basket or on the ground.
If performing the operation from the ground, make sure there is complete visibility of
the trajectory of each individual stabiliser before moving it and check that at the end of
the stabilisation procedure the distance between the ground and the lower limit of the
basket access ladder is less than 40 cm. If this is not the case, move the ladder to the
ground and carry out the stabilisation procedure from the basket.
‑ Select the motor speed as required and check the selection on the display.
Always perform stabilisation at slow speed.
‑ Press and hold the automatic stabilisation button 7 (see the corresponding paragraph).
If the movements are selected with the machine not completely closed and aligned, an
error message will be shown on the display.
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
81