JLG X17J Plus Operator Manual - Manual (Page 157)

9.2 ERROR MENU
Indicates correspondence between the double sensors, either (OK) or (FAULT).
The sensors are listed on different pages:
1 PREC ACCESS THE PREVIOUS PAGE
2 SUCC ACCESS THE SUCCESSIVE PAGE
9 EXIT
If the OK symbol is shown next to the sensor, this means that both elements on the same sen‑
sor are sending congruent information.
If the FAULT symbol is shown next to the sensor, this means that the elements on the same
sensor are sending incongruent information.
The last page of the error menu describes the error code relating to the battery charger
system, inverter and battery pack. Errors are indicated by the “spanner” icon in position 7 on
the remote control display.
If there are operating problems with the machine and the “spanner” icon is shown on the
display, contact service department.
9.3 OPERATING HOURS MENU
Indicates the number of machine operating hours.
9.4 SETTINGS MENU
The items in this menu are not normally accessible.
9.5 JOYSTICK MENU
Displays the signal that each individual joystick sends to the main board.
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
153