JLG X17J Plus Operator Manual - Manual (Page 82)

6.4.7 JIB ARM MOVEMENT FOR TRAVEL
To take on slopes from 10° to 15° in a longitudinal direction during travel, the jib arm can be
raised.
PERFORM THIS OPERATION ONLY WHEN REALLY NECESSARY. IN ALL OTHER
SITUATIONS, TRAVEL WITH THE MACHINE CLOSED AND ALIGNED.
Enabling of the jib is indicated by the icon in position 5 on the remote control.
The jib arm can be raised during travel only from the control position on the ground.
Before raising the jib arm for travel, check the following conditions:
‑
All the stabilisers must be lifted from the ground;
‑ No operators must be in the basket;
The control position on the ground must be used (the remote control must not be in
place in the basket);
‑ The aerial part safety device bypass key must not have been activated after the machine
has been closed and aligned.
If one or more of these conditions is not satisfied, the jib arm cannot be used and one of the
following error screens will be shown.
BOOM LIFT MODELS X17JPLUS
JLG
78 X17JPR0020413
ATTENZIONE
DANGER