JLG X17J Plus Operator Manual - Manual (Page 62)

5.4 SAFETY DEVICE BYPASS KEY
The machine has a key device that acts on the electrical circuit, bypassing the platform safety
systems. The device is situated on the cover of the electrical components compartment.
The use of this selector switch is illustrated in the following paragraphs on how to use the
machine.
Considering the hazard deriving from the use of the platform during the bypass of the
safety devices, carefully read the paragraphs regarding the use of the safety device release
key selector switch.
The key used to activate the safety device bypass is lead‑sealed on the side of the electrical
components compartment near the battery.
Force the lead‑sealing to remove it. After using the safety device bypass a JLG after‑sales
centre must be contacted in order to verify the causes that determined the need to use the
safety device bypass and to lead‑seal the key.
The safety device electronic control board records when the safety device bypass key is
used and the movements carried out during these operations.
The safety device bypass system is used to move the machine with a higher load than the
limit load allowed inside the basket; the overload alarm is nonetheless displayed and the
beeper warns the operator of the dangerous conditions. This device must only be used by
expert personnel trained on how to use the machine, while the end user, who does not
fully know the machine’s operating principles, is not allowed to use this device.
X17JPR0020413 58
BOOM LIFT MODELS X17JPLUS
JLG