JLG X17J Plus Operator Manual - Manual (Page 79)

6.4.6 TRAVEL
The JLG machine is a self‑propelled machine able to easily move on any type of ground, over
steep slopes (up to 15°) and, considering the small dimensions, to enter narrow openings.
One condition for travel is that the four stabilisers are lifted from the ground and the machi‑
ne is in the transport or stabilisation configuration.
Travel can only be controlled from the position on the ground, always keeping a minimum
distance of 1 metre from the machine during ALL control operations.
When controlling the machine, before travelling make sure that the control position guaran‑
tees a perfect view of the entire machine and EVERY obstacle that may be in the machine’s
trajectory.
If a very precise control of travel movements is required, the motor speed can be reduced by
means of the speed selector button on the remote control.
Pay attention to the overall dimensions of the machine, especially if the stabilisers are not
turned to the transport position.
It is prohibited to get on or off the basket if this is not completely lowered.
The machine is not type‑approved for road circulation. The work and autonomous
shifting areas must be appropriately delimited and with signs according to the laws
in force regarding this subject. The machine must be loaded onto type‑approved
machines for any movement on public roads.
‑ During control operations, always keep a minimum distance of 1 metre from the machi‑
ne.
‑ It is recommended to travel on flat surfaces with the stabilisers completely lifted and set
in the transport position, so as to reduce the overall dimensions of the machine.
Travel is only allowed with carriage extended to the maximum width whenever possible
in the place of travel. This makes steering easier and increases machine stability.
‑ The 2nd travel speed can only be used for travelling in a straight line on solid and
level ground.
ATTENZIONE
ATTENZIONE
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
75
DANGER
DANGER