JLG X17J Plus Operator Manual - Manual (Page 136)

ATTENZIONE
7.22.2 RECHARGING THE BATTERY THERMIC VERSION
‑ The battery must be recharged in well ventilated places, away from naked flames and
possible sources of sparks.
‑ Do not disconnect the cables with the engine running.
‑ The machine is equipped with an internal battery charger. To recharge the battery, con‑
nect the machine to the mains power supply and press the corresponding switch
(photo).
Before connecting the machine to the mains power supply.
‑ Make sure that the battery cutout switch is not disconnected.
Alternatively, it is possible to recharge the battery by proceeding as follows:
1)
Disconnect the terminals of the machine’s electrical system from the battery poles.
2) Remove the lid “A” (Figure 1).
3) Connect the cables of the battery charger to the battery poles and switch the recharger
on.
4) Once the charge has been completed, switch the device off before disconnecting it from
the battery.
5) Fasten the terminals to the battery poles, then protect them with a layer of pure vaseline
or another suitable substance.
6) Close the battery with the lid “A” (Figure 1).
The charging voltage must never exceed 14.7 Volts and the charge intensity must always
be limited to 0.2% of the value indicated on the lid.
X17JPR0020413 132
BOOM LIFT MODELS X17JPLUS
JLG
DANGER
IMPORTANTE WARNING