JLG X17J Plus Operator Manual - Manual (Page 102)

6.5.5 EMERGENCY OPERATIONS ON THE CARRIAGE: MOVING THE PLATFORM
STABILISERS USING THE HAND PUMP TO ALLOW THE MACHINE TO BE TRAN‑
SPORTED
To raise the stabilisers from the ground in order to be able to transport the machine, proceed
as follows:
‑ check that the machine is completely closed and aligned;
‑ remove the protection guard from the carriage distributor
compartment;
‑ activate the two proportional valves mounted on the two
distributors through the proper devices (A);
‑ to move the left stabilisers, move the switch on the hydraulic
hand pump to the corresponding position; manually switch
the aerial‑tracked part switch via the fuse in the centre of the
magnet, using the corresponding hand wheel;
‑ use the ON‑OFF coil levers and buttons (B) to enable the
required movement and simultaneously operate the hand
pump to deliver oil to allow the movement (photo C);
‑ to move the right stabilisers, move the switch on the hydrau‑
lic hand pump to the corresponding position;
‑ use the ON‑OFF coil levers and buttons (B) to enable the
required movement and simultaneously operate the hand
pump to deliver oil to allow the movement (photo C);
‑ At the end of these emergency operations fully unscrew the
knob of the aerial part/undercarriage part deviator, put the
protection back on the distributors
BOOM LIFT MODELS X17JPLUS
JLG
98 X17JPR0020413
T HE HYDRAULIC HAND PUMP CAN BE USED TO MOVE THE STABILISERS AND SET THE MACHINE IN
THE TRANSPORT CONFIGURATION ONLY AFTER CLOSING COMPLETELY THE AERIAL PART OF THE
PLATFORM
.
B
L EFT SIDE CARRIAGE DISTRIBUTOR
A ERIAL PART ‑ CARRIAGE SWITCH
A
A
R IGHT SIDE CARRIAGE DISTRIBUTOR
Photo C