Eppendorf D30 BioPhotometer - Manual (Page 13)

13
Safety
Eppendorf BioPhotometer ® D30
English (EN)
NOTICE! Corrosion from aggressive cleaning agents and disinfectants.
 Do not use corrosive cleaning agents, aggressive solvents or abrasive polishes.
 Do not incubate the accessories in aggressive cleaning agents or disinfectants for a longer
period of time.
NOTICE! Damage to electronic components due to condensation.
Condensate can form in the device after it has been moved from a cool environment to a
warmer environment.
 After installing the device, wait at least for 3 h. Only then connect the device to the mains.
NOTICE! Function impairment due to mechanical damage.
 After mechanical damage to the device, ensure that the measuring and evaluation
functions of the device are operating correctly by completing an inspection.
NOTICE! Damage from overheating.
 Do not install the device near to any heat sources (e.g., heating, drying cabinet).
 Do not expose the device to direct sunlight.
 Ensure unobstructed air circulation. Keep free a clearance of at least 5 cm around all
ventilation grilles.
NOTICE! Material damage from incorrect use.
 Only use the product for its intended purpose as described in the operating manual.
 Ensure adequate material resistance when using chemical substances.
 In case of doubt, contact the manufacturer of this product.
NOTICE! Damage as a result of incorrect packing.
Eppendorf AG is not liable for damage caused by improper packing.
 The device may only be stored and transported in its original packaging.
NOTICE! Damage due to improper cleaning of the cuvette shaft.
 Only clean the cuvette shaft using a moist cotton swab .
 Do not allow any liquid to enter the cuvette shaft.
 Do not reach with your fingers into the cuvette shaft.