Apple Logic (1.1) - Manual (Page 73)

Chapter 7 Mixer, Instruments, and Effects 73
• Click-holding on the desired parameter in the parameter area below the graphic
display (Frequency, Gain/Slope or Q): Moving up increases, and down decreases, the
value. In order to prevent accidental changes, this is the only way to change the
Slope value of the high and lowpass filters.
As long as your mouse cursor is in the access area of a band, its individual curve will be
graphically inserted over the resulting curve of the entire equalizer.
The Bypass button is used to bypass or activate the EQ.
Inserting Audio Effects
The internal audio effects of Logic can be inserted into the individual audio channelsby
selecting the desired effect from the hierarchical menu, accessed via the Insert slot(s)
found on each audio channel strip.
To insert an effect:
1 Open the Track Mixer, or launch the Audio layer of the Environment (Screenset 3 of the
default Song). Alternately, use the Arrange channel strip.
2 Once a mixing surface is open, click-hold on any of the Insert slots on the desired audio
channel.
3 A hierarchical pull-down menu will open, displaying the various effects, grouped in
categories. Usually, you would insert effects from the top slot down.
4 Highlight the category, then the effect name from the menu listing, and release the
mouse button. The Insert slot will turn blue, with the name of the selected effect
displayed, and a Plug-in window will launch.
5 To remove a plug-in from an Insert slot, click-hold on the desired slot and select No
Effect from the menu.
Note: Further information about Inserts and the use of plug-ins can be found in the
first part of the Logic Pro/Express 7 Plug-In Reference .