Apple PC Compatibility Card 12-inch card - Manual (Page 35)

21 Route the second cable over the top of the card, around the back of the logic board, and
through the hole in the computer’s chassis.
Keep the cable away from the heat sink and the center support post.
You’ll connect this cable to the CD-ROM drive in step 27.
1 Route the cable
around the back
of the computer’s
interior as shown.
Heat sink Support post
2 Feed the other end of the cable a few inches into
this hole in the computer chassis. You will attach the
end of the cable to the back of the CD-ROM drive later.
21 Installing the Card in a Power Macintosh 7200, 7500, or 7600