Apple PC Compatibility Card 12-inch card - Manual (Page 161)

Installing NetBEUI in Windows for Workgroups
This section describes the settings necessary to install the NetBEUI protocol
for use with an ODI driver in Windows for Workgroups. If you are using
NDIS 2.0, refer to this topic in “Installing Protocols for Use With NDIS 2.0”
later in this appendix.
1 Install the NetWare client software.
For more information, see “Installing NetWare Client Software” earlier in
this appendix.
2 In Windows, open the Network Setup control panel and select NetBEUI.
3 Make sure MACODI.COM is in the \NWCLIENT directory.
4 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
5 Make sure your configuration files contain the following:
NET.CFG
LINK DRIVER MACODI
FRAME ETHERNET_802.3
FRAME ETHERNET_II
FRAME ETHERNET_802.2
FRAME ETHERNET_SNAP
PROTOCOL NETBEUI F0 ETHERNET_802.2
NETWARE DOS REQUESTER
FIRST NETWORK DRIVER = F
AUTOEXEC.BAT (must begin with the following lines in this order)
C:\WINDOWS\NET START
@CALL C:\NWCLIENT\STARTNET
C:\WINDOWS\ODIHLP.EXE
147 Installing Network Client Software