Apple PC Compatibility Card 12-inch card - Manual (Page 149)

135 Adding Memory to a PC Compatibility Card
Removing the card
For detailed instructions, see the chapter earlier in this manual on installing
the PC Compatibility Card in your computer model.
1 If you have not already done so, remove the loopback cable from the port on the back of
the PC Compatibility Card.
2 Touch the metal part of the power supply case inside the computer to discharge any
static electricity that might be on your clothes or body.
Always do this before you touch any parts or install any components inside
the computer.
3 Locate the PC Compatibility Card.
4 Disconnect the cables attached to the card. Be sure to pull the connectors, not the cables.
Remember where the cables were attached so you can replace them later.
5 Remove the card by firmly lifting it straight up.
Grasp the card by its sides to remove it.
IMPORTANT Do not rock the card side to side as you remove it. Doing so may
break the card or damage the slot.