Apple PC Compatibility Card 12-inch card - Manual (Page 175)

Installing Microsoft TCP/IP-32 IP protocol stack and IPX/SPX in
Windows 95
This section describes how to set up the Microsoft TCP/IP-32 IP and
IPX/SPX protocols for use with an NDIS driver in Windows 95.
This section assumes that you are installing only the Microsoft TCP/IP
protocol. If you want to install additional protocols, you must modify the
PROTOCOL.INI file accordingly. The Apple Network Setup Utility included
with your PC Compatibility Card can add this information for you.
1 Start Windows 95.
2 Select Start, and then select Settings.
3 Select Control Panel; then double-click the Network icon to open it.
4 Select Add; then select Adapter.
5 Select Have Disk.
6 Insert the floppy disk containing the NDIS 2.0 driver. Verify the drive; then click OK.
7 You will see the message “PC Card Network Driver (NDIS2).” Click OK.
The following network items will be automatically installed:
m Client for Microsoft Networks
m Client for NetWare Networks
m PC Card Network Driver (NDIS 2.0)
m IPX/SPX-compatible Protocol
m NetBEUI
8 Perform any custom setting that you need (for example, enable file sharing).
If you want to intall the TCP/IP protocol only, then remove the other
protocols after you have installed the TCP/IP protocol stack first.
9 Cick Add, then Protocol and click Add. Under Manufacturers, select Microsoft. Under the
Network Protocols, double-click on TCP/IP.
10 Enter all the nessarry information to configure the TCP/IP stack. Double-click on TCP/IP
protocol under the “PC Card Network Driver (NDIS2)” and enter the necessary info.
161 Installing Network Client Software