Poison Spyder JK BODY ARMOR - Manual (Page 3)

INSTALLATION INSTRUC
TIO
NS
©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 5
7. Install the Body Armor using two 1/4” flat
head bolts. Make sure you place a small
amount of anti-seize on each bolt. Do not
over tighten the bolts; for this step you will
only need to snug them up.
8. Double check the fitment to make sure you
are happy with it.
9. Using the 1/4” drill bit, drill the rest of the
mounting holes using the Body Armor as
your drill guide. Make sure you do not drill
through the inner panel.
FIGURE 6
10. Remove the Body Armor and set aside.
11. Use the 25/64th drill bit and open up the
holes you just drilled. Take your time drilling
these holes; the larger drill bit may catch and
distort the hole. Make sure you do not drill
through the inner panel.
12. Apply some touch up paint to the areas
where bare metal is exposed; this will aid in
the prevention of corrosion.
13. Using the nut insert tool, install inserts into
the holes you just drilled. Do not over tighten
the nut inserts; this will cause them to distort
and not fasten to the body correctly.
14. Remove the tape from the back of the Body
Armor.
15. (Optional) If you purchased the rubber
liners, they will need to be placed on the
back side of the Body Armor. Use a couple of
bolts to help hold the liner in place.
FIGURE 7
16. For the final install it is helpful to have
someone assist you with lining things up.
See figure 14.
FIGURE 8
17. Install the Body Armor using 1/4” flat head
bolts. Make sure you place a small amount
of anti-seize on each bolt. Make sure you get
each bolt started before you tighten any of
the bolts up. Do not over tighten the bolts; for
this step you will only need to snug them up.
Poison Spyder Customs • JK BODY ARMOR INSTALLATION Page 3