Poison Spyder JK ROCKER KNOCKERS Frame-Mount - Manual (Page 4)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • JK ROCKER KNOCKERS FRAME-MOUNT Page 4
©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 9
7. Re-install the Rocker Knocker™. Re-use
the OE bolt at the front outrigger. At the
center outrigger, insert the supplied 3/16”
thick steel spacer between the mounting
flange and the frame rail, and secure it with
one of the supplied 1/2-20 X 1 Gr8 Hex Head
Cap Screws and 1/2” Flat Washer. At the
rearward outrigger, one of the supplied 1/2-
20 X 1 Gr8 Hex Head Cap Screws and 1/2”
Flat Washers (without the spacer).
FIGURE 10
8. Note that each outrigger is positioned
against an adjacent body mount bracket, and
that there is a pre-existing 3/8” hole in the
side of the outrigger. Using the hole in the
outrigger as the drill guide, drill a 3/8” hole
through the body mount bracket adjacent to
each outrigger.
FIGURE 11
9. Use the supplied 3/8” hardware to bolt the
outrigger to the side of each body mount
bracket, through the newly drilled holes.
Use the 3/8-16 X 1-1/2 Gr. 8 Hex Head Cap
Screws, Flat Washers and Lock Nuts at the
two rearward outrigger, and use the 3/8-16 X 1
Gr. 8 Hex Head Cap Screw, Flat Washers and
Lock Nut at the forward outrigger.
10. Move to the passenger side and repeat
the Rocker Knocker™ installation process
described in the previous steps. However,
on the passenger side you will re-use the OE
gas tank skid plate bolts for the two rearward
outriggers, instead of drilling and tapping
new holes. Begin the passenger side
install by removing the transmission skid
plate crossmember bolt (auto trans models
only), and the two gas tank bolts along the
underside of the frame rail that correspond
with the Rocker Knocker™ outrigger mount
flanges. When installing the passenger side
Rocker Knocker, use a pry bar to separate
the gas tank skid from the frame slightly so
that the Rocker Knocker mounting flange
can slip between the skid plate and the frame
rail. It may be necessary to have a friend
help with this step.