Installation instruc tio ns – Poison Spyder JK 07-10 BOLT-TOGETHER TRAIL CAGE User Manual

Page 3

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK BOLT-TOGETHER TRAIL CAGE KIT

Page 3

FIGURE 2

FIGURE 3

7. On the forward sheetmetal piece of the

factory header bar, locate the two screw clips

where the sun visor had attached. Remove

each one by pinching the metal clip from the

back side and pushing it out.

FIGURE 4

8. Look along the underside of the top of the

windshield frame, at each end, and locate the

rectangular hole with two smaller rectangular

holes (and a round hole) in the panel behind.

Insert the screw clips removed from the factory

header bar into the two small rectangular

holes, as shown in the photo below. You may

need to file a small amount of material off the

end of each clip for a proper fit. Push them in

until they are fully seated.

FIGURE 5

9. Remove the windshield wipers. Pry up the

plastic cover at the pivot point of the wiper

to expose the nut. Use a 13mm wrench to

remove the nut, then slide the wiper arm off

of the shaft.

FIGURE 6

10. Use a Torx T40 driver bit to remove the

windshield brackets from the lower corner

of each end of the windshield, then tilt the

windshield forward into the rubber bumpers

on the Jeep’s hood.

FIGURE 7