Installation instruc tio ns – Poison Spyder JK 07-10 BOLT-TOGETHER TRAIL CAGE User Manual

Page 10

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK BOLT-TOGETHER TRAIL CAGE KIT

Page 10

FIGURE 37

46. Re-install the fabric covers that go over the

foam pads at the B-pillar joints.

FIGURE 38

47. Re-install the factory sound bar to the

b-pillar crossover bar. Note that you will need

to trim the plastic sound bar fascia to fit around

the Front and Rear Center Stringers, as

shown in the photo below. Use a pneumatic

body saw or similar cutting device. Start with

an undersized opening and enlarge it a little

at a time, test-fitting the sound bar between

each pass, until it fits just right. Patience here

will pay off with a clean looking install. Once

the cuts are the correct size, use sandpaper

or a file to clean up the cut edges of the plastic

cover before final installation.

FIGURE 39

48. Re-install the factory inner door sill covers.

These will also need to be trimmed for

clearance around the new cage A-Pillar leg.

Consult the photo below, showing a stock sill

cover on the bottom and a properly trimmed

sill cover on top.

FIGURE 40

49. Use a pneumatic body saw or other suitable

cutting device to trim the plastic inner door

sill covers. Start by cutting off most of the

area shown removed in the photo above ,

intentionally leaving slightly more material

than needed. Then test fit, trim, and test fit

again until the piece fits properly into place.

Patience here will pay off with a clean looking

install. Once the cuts are the correct size, use

sandpaper or a file to clean up the cut edges

of the plastic cover before final installation.

FIGURE 41

50. Trim the carpet around the A-Pillar leg

where it meets the floor pan.

51. Reinstall the upper A-Pillar fascias, sun

visors and the rest of the fabric cage covers.

Trim to fit wherever necessary.