Installation instruc tio ns – Poison Spyder JK BRAWLER LITE FRONT BUMPER User Manual

Page 2

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK BRAWLER LITE FRONT BUMPER

Page 2

disconnect the wiring harness plugs from the

sockets at the back of each lamp. A small flat

head screwdriver may be useful to release

the tangs on the plug

4. Use a ratchet and 19mm deep socket to

remove the eight (8) nuts that fasten the

bumper to the frame. There are two of these

nuts on the inner side, and two on the outer

side, of each frame rail where it joins the

bumper.

FIGURE 3

With these nuts removed, remove the

bumper from the Jeep.

FIGURE 4

5. If your Jeep is equipped with factory fog

lamps, these may be removed from the stock

bumper and re-installed into the Brawler

Lite bumper. Use a Phillips screwdriver to

remove the four (4) retaining screws from

each lamp, on the back side of the bumper.®

FIGURE 5

Install the factory fog lamps into the fog lamp

mounts in the back side of the Brawler Lite

bumper. Re-use the OE retaining screws.

These sheetmetal screws will form their own

threads as you drive them into the retaining

rings on the RockBrawler bumper, so press

firmly as you twist the screwdriver.

FIGURE 6

6. Remove the plastic top bumper cover.

You may be able to remove the two plastic

screws with a Phillips screwdriver. But it is

likely they’re “frozen” in place and will have to

be pried up with the push-in retainer removal

tool.

FIGURE 7