Installation instruc tio ns – Poison Spyder JK ROCKBRAWLER II REAR BUMPER User Manual

Page 3

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK ROCKBRAWLER II REAR BUMPER

Page 3

FIGURE 5

13. Once the entire bumper is mounted and

tested for proper fitment, remove the bumper

for paint or powder coat. If painting yourself,

careful preparation will make a big difference

in the quality and longevity of your paint job,

even using “rattle can” aerosol paints. Begin by

thoroughly cleaning the bumper with solvent

or de-greaser, then make sure all residue is

removed. Even if you use cheap paint, try to

use a good quality primer. “Etching” primers

are best to use on bare, unpainted metal.

Allow it to properly dry before painting, and

between paint coats.

14. After the bumper has been painted or

powder coated, re-install by repeating the

above steps.

15. Torque the eight bolts (3 on each side and

two underneath) to 45 ft.-lbs.

16. Insert the supplied Black Plastic Cap into

the round hole on the passenger side top

surface of the bumper. Lightly tap it into place

until it is firmly seated against the surface of

the bumper.

17. If the optional 2-1/2” LED backup lamps

were purchased, use the provided rubber

grommets to mount them into the recessed

mounting flanges inside the backup lamp

buckets. Use the electrical pigtails that

came with the lamps, along with wire and

connectors (not included) to wire the backup

lamps in to your Jeep’s backup lamp circuit.

Congratulations, you have completed installation

of your RockBrawler™ II Rear Bumper!