Poison Spyder JK ROCKBRAWLER REAR BUMPER - Manual (Page 3)

INSTALLATION INSTRUC
TIO
NS
©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • JK ROCKBRAWLER REAR BUMPER Page 3
Begin by thoroughly cleaning the bumper
with solvent or de-greaser, then make sure
all residue is removed. Even if you use
cheap paint, try to use a good quality primer.
“Etching” primers are best to use on bare,
unpainted metal. Allow it to properly dry
before painting, and between paint coats.
14. After the bumper has been painted or
powder coated, re-install by repeating the
above steps.
15. Torque the eight bolts (3 on each side and
two underneath) to 45 ft.-lbs.
16. Insert the supplied Black Plastic Cap into
the round hole on the passenger side top
surface of the bumper. Lightly tap it into place
until it is firmly seated against the surface of
the bumper.
17. If the optional 2-1/2” LED backup lamps
were purchased, use the provided rubber
grommets to mount them into the recessed
mounting flanges inside the backup lamp
buckets. Use the electrical pigtails that
came with the lamps, along with wire and
connectors (not included) to wire the backup
lamps in to your Jeep’s backup lamp circuit.
Congratulations, you have completed installation
of your RockBrawler Rear Bumper!