Poison Spyder TJ FULL CAGE KIT - Manual (Page 5)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • TJ FULL CAGE KIT INSTALL Page 5
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 10
11. Install the C-Hoop 14 and the C-Pillars L&R
15 at the same time. Have a friend help
with holding the three pieces in place. Start
by holding the C-Hoop in place, extended
rearward from the downward bend on each
Main Side Hoop. Next, hold the two C-Pillars
in place vertically between the C-Hoop and
the lower ends of the Main Side Hoop. While
holding them in place correctly located, tack
the C-Hoop and C-Pillars into place.
FIGURE 11
12. Install the Rearward Stringers L&R 13
between the B-Crossbar and the inside
bends of the C-Hoop. Use the laser-etched
assembly marks to properly locate and align
the tube junctions. While holding them in
place correctly located, tack the Rearward
Stringers into place.
FIGURE 12
13. Install the Upper A-Pillar Tubes L&R 7
and the Dash Bar 9 at the same time. Have
a friend help with holding the three pieces in
place. Start by holding the Upper A-Pillar
Tubes in place between the Lower A-Pillar
and the Main Side Hoop. Next, hold the two
Dash Bar in place horizontally between the
C-Hoop and the lower ends of the Main Side
Upper A-Pillar Tubes. Use the laser-etched
assembly marks as guides to properly locate
the tube junctions. While holding them
in place correctly located, tack the Upper
a-Pillar Tubes and Dash Bar into place.
FIGURE 13
14. Install the Seatbelt Bar 16 to the rearward
side of the B-Pillars. Use the laser-etched
assembly marks as guides to properly locate
the tube junctions. Tack the Seatbelt Bar into
place.