Poison Spyder TJ FULL CAGE KIT - Manual (Page 4)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • TJ FULL CAGE KIT INSTALL Page 4
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 6
7. Install the Main Side Hoops L&R 6 , one
side at a time. Have a friend hold the Main
Side Hoop in place with the front portion
of the tube in contact with the Windshield
Mount Plate, with the tube end centered on
the plate. Hold the rearward end of the tube
so that it lands centered within the curved-
point area of the C-Pillar Mount Plate. Tack-
weld the Main Side Hoop to each plate
FIGURE 7
8. Install the B-Crossbar 12 between the two
Main Side Hoops. Reference the laser-
etched markings to correctly locate the
C-Crossbar along the inner side of each
Main Side Hoop. Tack the B-Crossbar into
place.
FIGURE 8
9. Install the B-Pillars L&R 8 between the
B-Pillar Mount Plate and the Main Side Hoop
on either side. Reference the laser-etched
markings to correctly locate the B-Pillar tube
along the Main Side Hoop. Tack the B-Pillar
into place.
FIGURE 9
10. Install the A-Crossbar 10 and the Forward
Stringers L&R 11 at the same time. Have
a friend help with holding the three pieces
in place. Start by holding the A-Crossbar
in place between the two Main Side Hoops,
toward the front of the Jeep. Next, hold the
two Forward Stringers in place between the
A-Crossbar and the B-Crossbar. Use the
laser-etched marks on each of the tubes to
properly locate the tube junctions. Use the
Forward Stringers to locate the A-Crossbar
the proper distance forward from the
B-Crossbar. While holding them in place
correctly located, tack the A-Crossbar and
Forward Stringers into place.