Hale MBP Booster User Manual
Page 87
❑ Preventive Maintenance
86
Silencer Series Booster Pump, p/n: 029-0020-83-0
13.
Stand the gearbox housing on its base and install the gasket and bear-
ing cover. Secure with 7/16-14 hex screws and hardware and torque to
50 ft.-lbs. (68 N-m).
It is recommended to manufacture insertion tools to assure correct
installation of the input shaft bearings and oil seal. (See Figure 6-11:
“Typical Bearing and Seal Insertion Tools,” on page 81.) Also see Figure
6-13: “Typical Angular Bearing Insertion Tool” on page 84. These draw-
ings are provided to assist in the manufacture of the tool.
14.
Install the drive unit cover and gasket cover. Secure in place using 5/16-
18 UNC screws and lock washers. For torque specs, see Table 6-3:
“Torque Values Chart” on page 62.
15.
Using Loctite™ PST or equal thread-sealing compound, install the
cooler compression fittings. Reinstall cooler lines.
16.
Install the pump onto the apparatus and check operation for leaks.
repair any immediately.