Hale MBP Booster - Manual (Page 69)

❑ Preventive Maintenance
68 Silencer Series Booster Pump, p/n: 029-0020-83-0
7. Carefully remove the assembly from the apparatus.
8. Place and support the pump assembly on a stable work stand/bench of suitable
capacity ( see “WARNING !” on page 67. ). Have the air vent and covers
exposed to provide easy and safe access to the internal parts.
Installing the Assembly to Apparatus
After completing repairs and/or maintenance, install the pump assembly to
the apparatus before filling with oil.
1. First, review preceding Section “Before You Begin...” on page 63.
2. Attach proper supporting devices and stabilize the assembly for transport to
the apparatus.
3. Place the pump assembly into position within the apparatus.
4. Connect the mounting brackets using the proper fasteners. Torque the
fasteners to proper values - see Table 6-3: “Torque Values Chart” on page 62.
5. Connect the drive shaft to the gearbox. Apply a coating of Loctite #246 High
Temperature Removable Thread Locker (or equal) to the fasteners and torque
to PTO manufacturer’s specifications.
6. Fill the gearbox to the proper oil level. See Section 4: Preventive Maintenance,
heading “Replace Gearbox Oil” on page 48.
7. Reassemble and reconnect all components removed to gain access to the
pump assembly, paying particular attention to your sketch and identification
match markings/tags.
8. Test the pump for proper operation per your departmental requirements. Note
and repair any leaks.
9. Recheck and top off oil levels.
10. Return the apparatus to normal operation.