Hale MBP Booster - Manual (Page 14)

13 Silencer Series Booster Pump, p/n: 029-0020-83-0
Safety Precautions
❑
❑ DO NOT operate the system at pressures higher than the maximum
rated pressure. (Also see Table 2-1: “Booster Pump Capacity” on page
13.)
❑ Relieve all system pressure, then drain all water from the system before
servicing any of its component parts.
❑ Use only pipe, hose and fittings which are rated at or above the maxi-
mum pressure rating at which the water pump system operates.
❑ If a pump is operated without water for extended periods, or without dis-
charging water, it could overheat. This can damage the mechanical seal
or the drive mechanism.
❑ DO NOT attempt to pump until all the “GREEN” pump indicators in the
cab and panel are ON. (Also see Figure 3-2: “Pump Operator’s Panel”
on page 27.)
❑ DO NOT advance the throttle unless the "OK TO PUMP" indicator is ON.
❑ DO NOT reduce the pressure on the INTAKE gauge below zero (0).
Serious damage to the water main could result.
❑ Use only PAC-EASE Rubber Lubricant Emulsion (or equal) on the rubber
mechanical seal parts to ease installation. DO NOT use other lubricant
types as damage to the mechanical seal and seat could occur.