Belkin PM01110EA - Manual (Page 44)

42
g Wireless router
sections table of contents 1 2 3 4 6 7 8 9 10 5
altErnatE sEtup MEthoD
5. My internet ip
1) Get Dynamically From isP: Gets WAN iP address from
isP automatically�
2) Use static iP address: Need to enter isP information below fields
(My iP Address)�
6. My ip address
Provided by your isP� enter the iP address here� (Only available when
user selects “Use static iP address” from iP Address Assignment above�)
7. My subnet Mask
Provided by your isP� enter the subnet mask here� (Only available when
user selects “Use static iP address” from iP Address Assignment above�)
8. Disconnect after X minutes…
This feature is used to automatically disconnect the router from your
isP when there is no activity for a specified period of time� For instance,
placing a check mark next to this option and entering “5” into the minute
field will cause the router to disconnect from the internet after five
minutes of no internet activity� This option should be used if you pay for
your internet service by the minute�
Setting Custom Domain Name Server (DNS) Settings
A “Domain Name server” is a server located on the internet that translates
Universal resource locators (Urls) like “www�belkin�com” into iP
addresses� Many internet service Providers (isPs) do not require you
to enter this information into the router� The “Automatic from isP” box
should be checked if your isP did not give you a specific DNs address�
if you are using a static iP connection type, then you may need to enter a
specific DNs address and secondary DNs address for your connection to
work properly� if your connection type is dynamic or PPPoe, it is likely that
you do not have to enter a DNs address� leave the “Automatic from isP”
box checked� To enter the DNs address settings, uncheck the “Automatic
from isP” box and enter your DNs entries in the spaces provided� Click
“Apply Changes” to save the settings�