Brocade Communications Systems 415 User Manual
Page 152
138
Brocade Adapters Administrator’s Guide
53-1001583-01
diag
B
--pciloopback
Checks the communications path between the host and the IO Controller
(IOC).
port_id
Specifies the ID of the port for which you want to send a health check
message.
-p pattern
Displays the data pattern.
-c frame_count Specifies the frame count.
--loopback
Tests the data path from the IOC to the desired network loopback point
(internal, serdes, external) and back. This is an offline diagnostic test.
port_id
Specifies the ID of the port on which you want to run a loopback test.
-t loopback_type Specifies the loopback test type. Possible values include the following test
types:
•
int - Internal loopback, the default
•
serdes - SerDes loopback
•
ext - External loopback).
If the loopback type is not specified, all loopback tests run.
-s speed
Specifies the link speed as 8, 4, 2, or 1 Gbps. This is an optional parameter. If
not specified, then 8, 4, and 2 Gbps speeds are tested on the 8 Gbps adapter
and 4, 2, and 1 Gbps speeds are tested on the 4 Gbps adapter.
-c frame count Specifies the frame count.
-p pattern
Specifies the pattern (must be one hex word).
--memtest
Performs a generic memory test using different algorithms.
port_id
Specifies the ID of the port on which you want to run a memory test.
--queuetest
Sends a health check message from the host to the firmware through
message queues memory mapped over the PCI.
port_id
Specifies the ID of the port on which you want to run a queuetest.
-q queue_num Specifies the CPE/RME queue number from 0 to 3. If the queue number is
not specified, all queues are tested.
Example
To display detailed information about a specific port:
# bcu diag
--
tempshow
temperature: 44.348787 C
# bcu diag
--
beacon 1/1 on
Port beacon turned on
# bcu diag
--
beacon 1/1 on
Link end-to-end beacon turned on
See Also