Brother BES-962BC - Manual (Page 37)

Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC 35
1. Attach four hexagon socket head cap screws to each of F table parts R
q
, M (2 pcs)
w
, and
L
e
from the back.
2. Mount the F table parts from L
e
in order. Insert the bent part (upper) of F table guide UN
r
into the guide. Insert the F table rear pin into the hole of leg cover
t
.
3. Adjust F table supports F
y
in height so as to make the F table lower than the bed top by 1 mm.
4. Tighten all hexagon socket head cap screws firmly.
5. Attach five thumb bolts to the lower front steel pipe of the leg section. Fasten the F table and
the leg section using F table stays A (3 pcs)
u
and B (2 pcs)
i
.
Procedure for embroidering with flat hoop/sash frame and every other head
Only the odd-numbered heads are operated for embroidering with flat hoop/sash frame.
Embroidering is possible within an area up to 500 mm in the X-axis direction.
1. Set the needle bar case in the needle bar No. 1 position. Remove the presser feet.
2. Select a flat hoop (sash frame) for every other head operation.
For embroidering with flat hoop/sash frame (upper position)
t
w
e
u
q
r
i
y
i
Pin