Brother BES-962BC - Manual (Page 31)

Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC 29
2-2 Installation of Machine
1. Place an adjustment bolt base
r
, a rubber
cushion 10
e
(provided with the machine),
and PE sheet
w
under each of four
adjustment bolts M20
q
. The adjustment
bolt base must be on the rubber cushion.
2. Fit four adjustment bolts M20
q
into the
conical dents of adjustment bolt bases
r
,
and adjust the embroidery machine in
height.
The adjustment must be made in such a
manner that the four bolts are under an
equal load when the machine is placed
down. (To lower adjustment bolt M20
q
,
turn it in the direction of the arrow.)
Also, the casters should be raised by
several millimeters.
3. After adjusting four adjustment bolts M20
q
, turn nuts M20
t
in the direction of the
arrow to fasten them.
Note) If the floor is not strong enough, the embroi-
dery machine may be rocked during opera-
tion. In such a case, it is recommended that a
secure base of concrete be placed below the
embroidery machine.
t
e
r
q
w