Brother BES-962BC - Manual (Page 159)

BES-962BC • BES-1262BC 157
Chapter 6 Embroidering
Boring
Turns on/off the machine boring mode.
The following items can be set:
Boring Sets ON/OFF of boring.
Shift data Shifts data by 15 mm to needle number 1. The screen display remains unchanged.
Boring can be set only for embroidery data which is prepared for boring. Make
sure that the data is correct before embroidering.
Install the following optional parts on the machine before embroidering.
• Boring knife
• Needle plate for boring
If the embroidery data for boring is zoomed in or out, or is rotated, embroidering
may not be correctly carried out.
1. Select [Boring] from Settings menu.
When the boring mode is on, the check mark ( ) appears at the top of [Boring] in the menu.
2. Click the setting item to put the check mark.
3. Click [OK].