Brother BES-962BC - Manual (Page 32)

Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC 30
2-3 Preparation of Needle Bar Case
BES-962BC
1. Loosen the bolt
q
and set screw
o
, and move the needle case
w
to the left.
2. Press the change bracket collar
r
against the change case base
e
on the light, while pressing
the change bracket collar
t
against the change case base
y
on the left, and tighten the bolt
q
and set screw
!0
. Check that needles at needle bar No.1 and 9 are inserted into the needle
plate holes smoothly.
Notes) • Check that the connecting shaft u does not have backlash in the horizontal direction.
• Never loose the bolt i of the change bracket coller r . If this bolt is loosened, the change bracket
coller r will be dislocated and the position of the needle bar case w will need to be adjusted.
r
q
u
w e
t
y i
o