Brother BES-962BC - Manual (Page 36)

Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC 34
Note) If the F table is kept at the height adjusted for embroidering with tubular square hoop, the cap frame may
interfere with the table. Lower the table by one level in this instance.
1. Attach four hexagon socket head cap screws to each of F table parts R
q
, M (2 pcs)
w
, and
L
e
from the back.
2. Mount the F table parts from L
e
in order. Insert the bent part (lower) of F table guide L
r
into the guide. Insert the F table rear pin into the hole of F table stopper N
t
.
3. Adjust F table supports F
y
in height so as to make the F table parallel with the floor.
4. Tighten all hexagon socket head cap screws
u
firmly.
q
y
r
e
t
y
u
r
w
For embroidering with cap frame (lower position)