Toshiba Satellite Pro 4320 - Manual (Page 90)

7-2 Setup and Password Security User's Manual
Satellite Pro 4200/4300 User's Manual – 4200_UK.doc – ENGLISH – Printed on 27/01/00 as IM_420UK
Executing TSETUP
1. Select Restart (the computer) in MS-DOS mode? from the Shut
Down
window.
2. After the computer reboots in MS-DOS, type TSETUP and press Enter.
TSETUP displays the SYSTEM SETUP screen.
The TSETUP screen is divided into two pages SYSTEM SETUP (1/2)
and SYSTEM SETUP (2/2).
MEMORY
Total = 65536 KB
BATTERY
Battery Save Mode = Full power
PASSWORD
Not Registered
DISPLAY
Power On Display = Auto-Selected
LCD Display Stretch = Disabled
TV Config.
BOOT PRIORITY
Boot Priority = FDD->HDD->CD-ROM
Power On Boot Select = Enable
OTHERS
Power-up Mode = Resume
CPU Cache = Enabled
Level 2 Cache = Enabled
Processor serial number = Disabled
Auto Power On = Disabled
Alarm Volume = High
System Beep = Enabled
Panel Power On/Off = Disabled
PERIPHERAL
Pointing Devices = Auto-Selected
Ext Keyboard "Fn" = Disabled
USB Legacy Emulation = Disabled
Parallel Port Mode = ECP
Hard Disk Mode = Enhanced IDE (Normal)
SYSTEM SETUP (1/2) ACPI BIOS version = x.xx
CONFIGURATION
Device Config. = All Devices
I/O PORTS
Serial = COM1(3F8H/IRQ4)
Built-in Modem = COM2(2F8H/IRQ3)
Parallel = LPT1(378H/IRQ7/CH3)
FLOPPY DISK I/O
Floppy Disk = (3F2H/IRQ6/CH2)
DRIVES I/O
HDD = Primary IDE(1F0H/IRQ14)
CD-ROM = Secondary IDE(170H/IRQ15)
PCI BUS
PCI BUS =IRQ11
SYSTEM SETUP (2/2) ACPI BIOS version = x.xx
PC CARD
Controller Mode = Auto-Selected
: €Select items Space, BkSp: Change values PgDn, PgUp: Change pages
Esc: Exit without saving Home: Set default values End: Save changes and Exit
The system setup screen
The Panel Power On/Off item appears only when the computer is in
Resume mode.