Starting the computer by password, Starting the computer by password -11 – Toshiba Satellite Pro 4320 User Manual
Page 85
User's Manual
Power and Power-Up Modes 6-11
Version
1
Last Saved on 27/01/00 18:20
Satellite Pro 4200/4300 User's Manual – 4200_UK.doc – ENGLISH – Printed on 27/01/00 as IM_420UK
6.
Slide the battery latch into place to secure the battery pack.
Securing the battery cover
Starting the computer by password
If you registered a password as supervisor or user, you must enter it to
start the computer. If you forget your password, use the password service
diskette. For more information about how to set a password and make a
password service diskette, refer to the Password security section in
Chapter 7,
To start up the computer with the password, follow these steps:
1.
Turn on the computer as described in Chapter 3,
the following message appears:
Password =
At this point, the hotkeys Fn + F1 to F5 do not work. They will function
after you enter the password.
2.
Enter the password.
3.
Press Enter. The computer displays the message below while it starts up.
Valid password entered, system is now
starting up.
If you have set a password and the computer boots by the alarm Power
On function and Resume is on, the computer will start with the instant
security function enabled. The password = message is not displayed;
however, you must enter the password to use the computer.