Toshiba Satellite Pro 4320 - Manual (Page 105)

User's Manual Setup and Password Security 7-17
Version
1
Last Saved on 27/01/00 18:20
Satellite Pro 4200/4300 User's Manual – 4200_UK.doc – ENGLISH – Printed on 27/01/00 as IM_420UK
6. a.) If character strings match, the password is registered and the
display changes to:
SUPERVISOR PASSWORD = Registered
USER PASSWORD MODE = Unable to run SETUP
Do you want to change the setting ?
If you do not want to provide user access to the TSETUP program,
press N to return to the DOS prompt.
To provide user access to TSETUP, press Y and continue with the
procedures in the section Enabling TSETUP in this chapter.
b.) If the character strings do not match, the following message
appears:
Password verify error!
Do you want to retry ?
Press Y to return to step 3. Press N to return to the DOS prompt.
User password
To enter a user password, execute TSETUP, then:
1. Go to the Password item and press the Space or BkSp key to
display the following prompt:
Password =
2. Enter a password of up to 10 characters. The character string you
enter is displayed as a string of asterisks. For example, if you enter a
password consisting of four characters, the display is shown as:
Password = ****
If you press Enter before entering the password, Not registered will
appear on the display.
3. Press Enter. The following message appears, allowing you to verify
the password.
Verify Password =
4. If character strings match, the password is registered and the display
changes to:
Registered
If they do not match, the following message appears along with a beep
indicating you must repeat from step 2.
Entry Error!!