Pioneer ANH-P10MP - Manual (Page 86)

Audio Adjustments
En
11
Section
86
• If you switch the SFEQ setting, the HPF func-
tion is automatically turned off. By turning the
HPF function on after selecting the SFEQ set-
ting, you can combine HPF function with
SFEQ function.
Adjusting equaliser curves
You can adjust the currently selected equalis-
er curve setting as desired. Adjusted equaliser
curve settings are memorised in
CUSTM.
You can adjust the centre frequency and the Q
factor (curve characteristics) of each currently
selected curve band (low, mid, high).
1 Press AUDIO and then press EQ.
Centre frequency
Level (dB)
Q factor
Each band (low, mid, high)
2 Press or to select the equaliser
band to adjust.
Each press of or selects equaliser bands
in the following order:
Low—Mid—High
3 Press FREQ and then press
or to
select the desired centre frequency.
Press or until the desired centre frequen-
cy appears in the display.
Low:
40—80—100—160 (Hz)
Mid: 200—500—1k—2k (Hz)
High: 3.15k—8k—10k—12.5k (Hz)
4 Press LEVEL and then press
or to
adjust the level of the equaliser band.
Each press of or increases or decreases
the level of the equalisation band.
“
+6” – “–6” is displayed as the level is in-
creased or decreased.
5 Press Q and then press
or to select
the desired Q factor.
Press or until the desired Q factor ap-
pears in the display.
2N—1N—1W—2W
Note
If you make adjustments, CUSTM curve is updat-
ed.
Using balance adjustment
You can select a fader/balance setting that
provides an ideal listening environment in all
occupied seats.
1 Press AUDIO to select F/B (fader/bal-
ance).
2 Press or to adjust front/rear
speaker balance.
Each press of or moves the front/rear
speaker balance towards the front or the rear.
“ FADER F15” – “FADER R15” is displayed as
the front/rear speaker balance moves from front
to rear.
“ FADER FR00” is the proper setting when only
two speakers are used.
When the REAR setting is “SUB.W”, you can-
not adjust front/rear speaker balance. Refer to
Level (dB)
Centre frequency
Q=2N
Q=2W
Frequency (Hz)