Pioneer ANH-P10MP - Manual (Page 82)

En
10
Section
82
TV Tuner
Using the TV tuner
You can use this product to control a TV tuner,
which is sold separately.
For details concerning operation, refer to the
TV tuner’s operation manuals. This section
provides information on TV operations with
this product which differs from that described
in the TV tuner’s operation manual.
Preset number indicator
Shows what preset has been selected.
Band
Shows which band the TV tuner is tuned to.
Channel indicator
Shows which channel the TV tuner is tuned.
Operation
1 Press SOURCE until “Television” ap-
pears.
2 Use VOLUME to adjust the sound level.
3 Press BAND/ESC to select the desired
band.
Press
BAND/ESC repeatedly to switch be-
tween the following bands:
TV–1—TV–2
4 To perform manual tuning, press or
briefly.
5 To perform seek tuning, press and hold
or for about one second and release.
You can cancel seek tuning by pressing either
or briefly.
Storing and recalling
broadcast stations
If you press any of the buttons 1 – 6 (or 7 –
12), you can easily store up to 12 broadcast
stations for later recall.
1 Press NEXT until “1” – “6” or “7” – “12”
appear.
2 When you find a station that you want
to store in memory, press and hold any of
the buttons 1 – 6 (or 7 – 12) until the pre-
set number stops flashing.
The station is stored in memory at the select-
ed button.
The next time you press the same preset tun-
ing button
1 – 6, the stored station is recalled
from memory.
Notes
• Up to 12 stations, 6 for each of two TV bands
can be stored in memory.
• You can also use and to recall broadcast
stations assigned to preset tuning buttons 1 –
6 and 7 – 12.